Insert Part

INSERT PART adds any other CC3 drawing, as a part, to the working drawing. One part at a time is inserted.

CC3 displays the Part to Insert dialog box. This is the standard File Selection dialog box. To select a part to insert:

· Double-click a filename;

· Select a filename using the cursor and choose Open;

· Type a drawing filename from the list of available drawings.

CC3 displays the Insert Part dialog box. You may adjust part scaling and rotation.

· The default scaling is 1.0 (same size as the original part). Type in a new scale factor if you wish to insert the part at a larger or smaller size.

· The default XY rotation angle is 0.0°. If you wish to rotate the part upon insertion, type in a new rotation between 0 degrees and 360 degrees. For example, type "45" to rotate the part 45 degrees counter-clockwise.

Choose the OK button to accept the scaling and rotation values.
The prompt reads "Insert at:". Enter an insertion point by using the crosshairs, or type numeric coordinates.

CC3 draws the contents of the part file at the insertion point

The prompt continues to read "Insert at:". Continue inserting copies of the part if you wish. Right-click to end the command.

To remove the new entities:

Use the UNDO command ( $image\UNDO.gif$ ). If you inserted multiple parts, UNDO removes them all.

To ungroup the new entities:

The parts are inserted as groups. Select Insert > Ungroup and select by PRIOR to ungroup them.

Text equivalent: PART